How To Winterize An Above Ground Pool With A Sand Filter. 3) turn off the blower and change the filter head setting to winter. A sand filter is unique in design because as the sand ages, it can actually become more effective at trapping and filtering the debris and bacteria commonly found in above ground pools.
Be sure the water is flowing freely from it. Before you winterize your above ground pool, it is imperative that you test your pool chemistry to figure out which all chemicals are balanced and which all are not.
24ft X 12ft X 52in Ultra Frame Rectangular Pool Set With
Besides, you can also use it in the lower pool line. Check the alkalinity, ph, phosphate, and calcium levels to see if your pool is safe.
How To Winterize An Above Ground Pool With A Sand Filter
Disconnect your pump and filter.Finish by using pool pillows and covers to winterize your pool.First, backwash the filter until the water that runs out is clear.Fold your intex pool liner ;
For instance, you have to wash the sand filter as well if it is in the pool.How much water do you drain from above ground pool for winter?How to vacuum pool with sand.How to winterize intex pool in warm climates.
If you do have a deck around the pool, place water bags 3/4 full of water on the edges of the pool cover to weigh it down.If you don’t have a deck all the way around the pool, thread the cable through the grommets or loops then tighten the cover to hold it securely in place.If you have a bleeder valve or air vent valve on your sand filter you should open this as well.Keep and store the plug or cap.
Learning how to change the sand in a pool filter can be an easy task but also slightly daunting since it is only recommended to change your sand every 3 years.Make sure the water has drained out of the pump.Most of the people, while winterizing the pool, use the skimmer guard for cleaning the skimmer.Move dial valve setting from backwash to rinse.
Next, clear the skimmer and fully drain the pump.Next, rotate the control valve according to its appropriate setting.Note that attempting to use sand that is too coarse or too fine will impede the effectiveness of the filter.Now with all of these extra ports open you can turn on the blower again which will cause some mist to blow out of the ports on your filter.
Place a winter cover over your pool with the black side down.Place the lid atop the container and insert the supply line into the top.Place the sand filter, water pump, hoses, the drain cap and pressure valve in a dry, safe place until the pool is ready to be used again.Remove the drain cap from the underside of your filter.
Remove the filter hose from the pool wall, and hook up the hose you use for vacuuming, this will allow most of the water to drain well away from the pool.Remove the filter’s drain plug;Remove the hoses that are attached to the pool and the pump.Rinse for approximately to 1 minute to remove any sand from the lines.
So it depends on your preference.So your heater should be off for fifteen to twenty minutes before you start to winterize the pump.Store the pool frame, pump, hoses, and other components inside.Then, unplug the pump carefully.
They are usually located near the bottom of the tank.To be extra sure you can hold it upside down to remove excess water.To finish getting rid of the water in your filter tank and prepare it for storage, go ahead and detach all pool hoses, connections, the tank cover, and all bolts on the lid of the filter tank.To winterize an above ground pool, begin by cleaning out your pool and removing any accessories.
Turn off the filter system.Turn off the filter system.Turn off the power to your pump.Turn the filter system on.
Use only pool sand available at a pool supply store.What happens if you don’t winterize your pool?While you’re testing your pool chemistry, it is highly recommended that you keep a close eye on the parameters such as ph , alkalinity , and calcium hardness.Winterize intex pool accessories ;
You can siphon, pump or drain your pool for the winter here is one way to lower the water;You might think that it is compulsory to remove all the water from an above ground pool.