How To Light Pilot On Rv Water Heater. A functioning pilot light should appear blue in color, which can help you determine whether or not your pilot light is working. A pilot light is a small flame present to ignite the gas burner on your water heater.
Adjust main burner air shutter approximately 1/4 open Although the rv water heater has different models and brands, most rvs have the same steps that you are able to apply to your unit.
Atwood Water Heater Gas Control Valve Replacecement Rv
Check out the video above to see whether or not this is an easy fix or a more difficult one. Dan, a couple things to consider;
How To Light Pilot
On Rv Water Heater
Hold the pilot knob for up to a minute.How do you light an electronic ignition water heater?How to operate the rv water heater.If air is getting into the lp lines somewhere, it can be hard for the water heater to light.
If it lights easily, then you most likely have air entering the system somewhere.If no gas smell is present you are ready to light the pilot light.If there is no release of any combustion agent, the pilot light will fail to start.If you move the rv or it will sit for a long period of time, then go ahead and turn it off between uses.
If you’re camping in the same spot for an extended period of time and actively using your appliances, you can leave the pilot light lit.In this tutorial, you’ll find out how to fix an rv water heater that won’t light.Let’s start by explaining the water heater pilot light so you can better understand how it functions.Light the pilot light the pilot with a long match or lighter, continuing to hold down the pilot knob.
Lighting a hot surface ignition:Locate the on/off control knob for the pilot light and turn the knob to the pilot setting on the unit.Set inlet pressure at a minimum 11 w.c.Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold.
The electronic igniter, will either light the pilot light or will light the gas directly.The pilot light starts after the igniter sparks, which causes this flame to activate the water heater.The propane has to travel from the control valve, through the orifice and down the mixing tube and mix with some fresh air.The propane has to travel from the control valve, through the orifice and down the mixing tube, mix with some fresh air, before reaching the pilot flame.
The valve is located on the exterior side of the rv and utilizes a standing pilot light which has to be lit from the outside of the rv.There will always be a brief delay from the time you move the control valve from pilot to on before the main flame ignites.These models allow the user to flip a switch inside the rv to light the propane burner on the water heater.This can happen when the water heater’s location does not have enough combustible air, for example, in a utility closet.
This is the most common type of water heater in today’s rvs.This toes into the category of dangerous, since such situations may result in carbon monoxide buildup.This will start the flow of gas so you can light the flame.To find out if this is the problem, light your stove burners, leave them going, and then turn on the water heater.
Turn the gas knob to “pilot,” press and hold it down.Turn the temperature control valve to the lowest setting on the dial of the control assembly.Water heater pilot light issues:While still holding the gas down, light that pilot.
With a lack of combustible air, the pilot light of your water heater is likely to go out.With two or more appliances running:You need to check the water heater bypass valve.You should be able to see the flame once it lights.
You should open it and let the water flow into the tank.You will need to know how to properly light your electric ignition water heater.Your gas release or electric heating element is malfunctioning.