How To Install Bathroom Sink Drain Rod. After loosening the lock nut, hold the. Also, the cleaning process is easy and quick.
Check that instructions on how to install a bathroom sink drain and how to install a bathroom sink drain pipe before commencing with the work. Clean this excess silicone from the sink and drain.
Featuring open grid, push button, and lift rod styles, these drains have options for sinks with or without overflow and come in an assortment of finishes. From the underside of the sink add the rubber gasket and metal locking nut to the drain.
How To Install Bathroom Sink Drain Rod
Locate the large nut that connects the sink to the drain and disconnect it.Look under the sink and push back the pivot to engage it with the hold at the stopper’s bottom.Next, find the washer that will fit onto the drain under the sink.No washers are required here.
Our solution is to apply 100% silicone sealant to the underside of the drain and to the sink.Picture shows old rusted piece and new replacement parts side by side.Place a slip joint nut on the pipe first, followed by the washer.Plug the hole where the rod went in with plumber’s epoxy.
Push and pull the knob behing the basin mixer to open and close the plug.Push the drain body down into the sink until silicone oozes out from the connection.Side plastic gasket over the pin shaft, which is a long rod with a pair of large ball close to one end, until the ball rests on the pivot.Step#5 installing the drain and water pipes.
The collar (nut) on this unit did not fit my sink (too small) and the ball and rod were a little larger but i reused the old nut and it all worked just fine.The first thing you need to do is to connect that drain in the hole underneath your basin.The horizontal rod will slide through one of the holes in the strap and the metal clip will slide onto the horizontal rod to keep it in place.The lever system is designed to pass through the same basin hole as the basin mixer so there is no need to have another hole in the basin this top quality product will add lasting function and beauty to your bathroom.
The next step is to install these drain and water pipes.The pivot nut is threaded onto a short stub on the drainpipe, and is the entry point for the pivot rod into the drain.Then in reverse of the steps above remove the vertical push rod and horizontal pivot rod connections to the drain.Then, tighten up the retaining nut while the stopper is in the up position.
This locks the drain in place.This metal or plastic nut will be located either in the wall or the floor.Throw away the stopper, rod, linkage and nut.To do this, place the stopper back in the drain hole.
To remove a sink drain you would first disconnect and remove the trap.Unscrew the pivot nut and pull it out with the pivot rod.Use a rubber stopper on a chain.Use your hands or locking pliers to unscrew the.
We liked that there is no need to remove the ball rod from the bottom of the sink.With flexible design, this sink drain is easy to install in.You can also loosen the clevis set screw and tweak the strap up and down until it moves the pivot rod to move the stopper.You simply slip a nut onto the waste drain and press it against the other pipe, then hand tighten the nut.
You’ll note one of them is much too loose, but the other one fits just right.